On Mac - was able to connect successfully to power meter/cadence device without issue yesterday. Recording was fine and the power/cadence metrics looked correct.
Today, I’m able to connect to my device, but metrics will not update unless I completely stop pedaling and then start back up again. It will record the first second or so of information…then it will freeze on the last known metric (sitting at xx Watts/xx RPM).
The only thing that has changed from yesterday’s session and today’s attempt…I’ve updated my ELITE Sterzo firmware. I don’t think that would cause issue here, but can’t rule it out either.
Any workarounds? My version on Mac is 1.15.1 (75994).